IR code to control a Samsung Home Theater System model HT-F5500W with the Xfinity rem

#1
I need the IR code(s) for Samsung Home Theater System using Xfinity remote.


This question, "IR code to control a Samsung Home Theater System model HT-F5500W with the Xfinity remote?," is about XFinity-Comcast TV television equipment.

For other news regarding IR code to control a Samsung Home Theater System model HT-F5500W with the Xfinity remote?, and XFinity - Comcast television equipment, see our recommended stories below.
 
G

Guest

Guest
#3
Program your Comcast remote
Program your remote using the RF pairing:

Install the remote control batteries and make sure your TV and set-top box are powered on.
Press and hold the "Setup" button until the LED at the top of the remote changes from red to green.
Press the XFINITY button
Enter the 3 digit code shown on your screen
Program your remote using a code:

Turn on the Audio/Other you are programming.
Press and hold the "Setup" button until the status LED at the top of the remote changes from red to green.
Type in the 4-digit or 5-digit code listed below using the number buttons. Additional codes may be found in the remote manual.
Most likely code
32660
Others to try
31949, 31868, 31950, 32137, 31304
If the code is entered correctly, the status LED will flash green twice. If the status LED blinks red, then green the code was not entered correctly. Check that you are entering the correct code and try again.
Use the remote to operate your Audio/Other (use Power, VOL, etc.)
If these steps don’t work, try another 4-digit or 5-digit code and repeat the above.
Learn more about your Comcast remote


The voice remote

About your remote
Troubleshooting
Manual (PDF)
 
Top